Clearing Media Jams; Clearing A Cassette Area Jam - Xante AW 1200 User Manual

Fuser Area
Cassette
Area
Fig. 8.2 Jam Areas
Use one of the procedures in the following section to locate and remove a media jam.
Never touch areas labelled "Hot Surface" or labelled areas around the fuser; this could
cause an electrical shock or burn.
If media wraps around the heat roller or you see smoke coming from the printer,
immediately turn off the printer and disconnect the power source. Then, contact XANTÉ
or your XANTÉ vendor. Do not try to remove media from around the heat roller.

Clearing Media Jams

This section describes removing media jams from specific locations.

Clearing a Cassette Area Jam

Remove media jams slowly and carefully to prevent tearing the paper. Media scraps in
the printer can become a fire hazard.
This basic procedure works for all cassettes (standard, multipurpose, or optional).
1. Remove the standard or multipurpose cassette by lifting it gently and pulling
straight out (fig. 8.3).
Fig. 8.3 Remove Cassette
8-14 – Troubleshooting
Fig. 8.4 Remove Jammed Media