Return; Audio - Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual

Camera menu items (continued)
V-LOG OUTPUT SELECT [V-LOG, V-709]
Select the signal output when [V-LOG] is [ON].
V-LOG Output with a gamma curve that has a wide range of
tones and latitude (exposure range).
V-709 Converted for output to images suited to previewing.
<NOTE>
• This cannot be set when the [BASIC CONFIG] – [V-LOG] is [OFF].
VIDEO SAMPLING [4:2:2/10bit, 4:2:0/8bit]
When [FORMAT SELECT] in [HDMI] is [2160/59.94p], [2160/60p]
or [2160/50p], select the video sampling output from the HDMI
connector.
<NOTE>
• When [FORMAT SELECT] in [HDMI] is other than [2160/59.94p],
[2160/60p] or [2160/50p], [VIDEO SAMPLING] cannot be changed
and is fixed at [4:2:2/10bit].
CHAR [OFF, ON]
Set whether to superimpose the OSD.

RETURN

RETURN1 ID
You can give a name to the return images (SMPTE ST2110 input
images).
It can be 5 characters.
Alphanumeric characters, spaces, ! # % & ' ( )
_ ~ $ @ |
The name you set is superimposed on the images output from
the same connector when [RETURN] is selected in [OUTPUT] –
[3G SDI OUT2/PM] – [OUTPUT SELECT].
<NOTE>
• This item cannot be set if the SMPTE ST2110 software key
(AW-SFU60) is disabled.

AUDIO

AUDIO [OFF, ON]
INPUT1 SETTING
INPUT2 SETTING
+ , - . / : ; < = > ? [ ]
*
56
Turn AUDIO input OFF/ON.
INPUT SELECT [LINE, MIC, MIC+48V]
Set the input switching for AUDIO INPUT1.
LINE Sets to LINE input.
MIC Sets to microphone input.
MIC+48V Sets to phantom power supply +48V microphone input.
This is only enabled when [AUDIO] is set to [ON].
MIC GAIN [60dB, 40dB]
Set the microphone amplifier gain for the AUDIO INPUT1 microphone
input.
This is enabled only when [AUDIO] – [INPUT1 SETTING] – [INPUT
SELECT] is [MIC] or [MIC+48V].
LINE LEVEL [+4dB, 0dB]
Set the input level for the AUDIO INPUT1 line input.
This is only enabled when [AUDIO] – [INPUT1 SETTING] – [INPUT
SELECT] is set to [LINE].
INPUT SELECT [LINE, MIC, MIC+48V]
Set the input switching for AUDIO INPUT2.
LINE Sets to LINE input.
MIC Sets to microphone input.
MIC+48V Sets to phantom power supply +48V microphone input.
This is only enabled when [AUDIO] is set to [ON].
MIC GAIN [60dB, 40dB]
Set the microphone amplifier gain for the AUDIO INPUT2 microphone
input.
This is enabled only when [AUDIO] – [INPUT2 SETTING] – [INPUT
SELECT] is [MIC] or [MIC+48V].
LINE LEVEL [+4dB, 0dB]
Set the input level for the AUDIO INPUT2 line input.
This is only enabled when [AUDIO] – [INPUT2 SETTING] – [INPUT
SELECT] is set to [LINE].