Table of Contents
Advertisement
Web screen configurations (continued)
Tone [Off, On]
Make the settings for the test tone signal (1 kHz) output while the
color bar is displayed.
Off
Test tone is not output.
On
Test tone is output.
Factory settings: On
z TALLY
Tally [Disable, Enable]
[Disable] or [Enable] is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Factory settings: Enable
Tally Brightness [Low, Mid, High]
Adjust the brightness of the tally LEDs.
Factory settings: Low
Tally LED Limit
Sets whether to limit the lighting of the tally lamp for each of the tally
control signal colors (R/G/Y).
R [Unlimit, Limit]
G [Unlimit, Limit]
Y [Unlimit, Limit]
Unlimit
Light the tally lamp.
Limit
Limit the lighting of the tally lamp.
Factory settings: Unlimit
<NOTE>
• If [Limit] is selected for [Tally LED Limit], only the tally lamp of this
unit is limited. The tally status display on external devices (the AW-
RP150, AW-RP60 controller, etc.) remains enabled.
Tally Guard [Off, On]
The following functions are suppressed during input of only the R tally
signal:
- Auto white balance and auto black balance operation
- OSD menu display
- OSD status indicators
Factory settings: Off
External Output
Select the type of signal to be output from the External Output signal
lines (Output1 and Output2) of the RS-422 connector. (→ page 20)
Output1 [Off, R‑Tally, G‑Tally, Y‑Tally]
Output2 [Off, R‑Tally, G‑Tally, Y‑Tally]
Off
Signal is not output.
R-Tally
The reception status of the red tally signal is output.
G-Tally
The reception status of the green tally signal is output.
Y-Tally
The reception status of the yellow tally signal is output.
Factory settings: Off
z SYNC SIGNAL
Make settings to synchronize video/audio output signals.
REF SIGNAL
BBS/TRI-LEVEL
Synchronization is according to the SDI reference
SYNC
signal from the G/L connector.
PTP
Synchronization is according to the PTP from the
SFP+ connector.
Factory settings: BBS/TRI-LEVEL SYNC
<NOTE>
• [PTP] cannot be selected when the SMPTE ST2110 upgrade key
(AW-SFU60) is disabled.
• When [Basic Config] – [SFP+ Mode] is [12G Output], [PTP] cannot
be selected.
• When [IP Signal] – [ST2110] – [MoIP Mode] is [Off], [PTP] cannot
be selected.
GENLOCK
This item is selected to perform the phase adjustments.
H PHASE-COURSE [–5 to 5]
This is used to adjust the horizontal phase during genlock.
Factory settings: 0
H PHASE-FINE [–100 to 100]
Make fine adjustments to horizontal phase in genlock.
Factory settings: 0
<NOTE>
• This cannot be set when the [Basic Config] – [Sync Signal] –
[Ref Signal] is [PTP].
115
Advertisement
Table of Contents
