Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual page 141

Web screen configurations (continued)
Input Setting 2
Input Select [LINE, MIC, MIC+48V]
Set the input switching for Audio Input2.
LINE Sets to line input.
MIC Sets to microphone input.
MIC+48V Sets to phantom power supply +48V microphone input.
This is only enabled when [Audio] is set to [On].
Factory settings: LINE
Mic Gain [60dB, 40dB]
Set the microphone amplifier GAIN for the Audio Input2 microphone
input.
This is enabled only when [Audio]
[MIC] or [MIC+48V].
Factory settings: 60dB
Line Level [+4dB, 0dB]
Set the input level for the Audio Input2 line input.
This is enabled only when [Audio]
[LINE].
Factory settings: 0dB
Output Setting
Display the setting status of audio output.
CH Select [Input1/Input2, Input1, Input2]
Select the audio output destination.
Input1/Input2 CH1-Input1/CH2-Input2
Input1 CH1-Input1/CH2-Input1
Input2 CH1-Input2/CH2-Input2
Factory settings: Input1/Input2
<NOTE>
• When [CH SELECT] is [Input1], the Input2 Audio of ST2110 is not
output.
• When [CH SELECT] is [Input2], the Input1 Audio of ST2110 is not
output.
CH1 Volume Level
[–40dB to 0dB to +20dB (1dB step)]
Set the volume for CH1 audio output.
Factory settings: 0dB
CH2 Volume Level
[–40dB to 0dB to +20dB (1dB step)]
Set the volume for CH2 audio output.
Factory settings: 0dB
Head Room [FS-12dB, FS-18dB, FS-20dB]
Set the audio head room (base level).
‒12dBFS
FS-12dB
‒18dBFS
FS-18dB
‒20dBFS
FS-20dB
Factory settings: FS-12dB
[Input2 Setting] [Input Select] is
– –
[Input2 Setting] [Input Select] is
– –
z Audio over IP
The setting is confirmed with the [Set] button.
Audio transmission [Off, On]
Set the communication mode used to transmit audio data to a
personal computer, etc.
Off Do not transmit audio data. All settings and controls
related to audio will be disabled.
On Transmit audio data.
This allows audio as well as images to be viewed on the
personal computer.
Factory settings: On
Audio bit rate [64kbps, 96kbps, 128kbps, 256kbps]
Set the bit rate for transmitting audio.
Factory settings: 128kbps
z Audio over ST2110
ST2110 Audio Format
Input1 audio TX [1ms/8ch, 0.125ms/8ch]
Set the format for AUDIO (Input1 audio TX) of SMPTE ST2110.
Factory settings: 1ms/8ch
Input2 audio TX [1ms/8ch, 0.125ms/8ch]
Set the format for AUDIO (Input2 audio TX) of SMPTE ST2110.
Factory settings: 1ms/8ch
<NOTE>
• This item cannot be set if the SMPTE ST2110 software key
(AW-SFU60) is disabled.
• This cannot be set when the [Basic Config] – [SFP+ Mode] is
[12G Output].
141