Table of Contents
Advertisement
Web screen configurations (continued)
CLIP(+) [00 to 63]
Set the level of clipping of the detail signal in the plus direction
(brighter direction).
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
CLIP(–) [00 to 63]
Set the level of clipping of the detail signal in the minus direction
(darker direction).
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
KNEE APERTURE LEVEL [00 to 39]
Adjust the level of detail for very bright parts.
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
DETAIL KNEE [00 to 15]
Adjust the detail component of knee.
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
LEVEL DEPRENDED SWITCH [Off, On]
Set On/Off for the level of reduction in detail in dark parts.
This is only enabled when [DETAIL] is set to [On].
Factory settings: Off
LEVEL DEPENDENT [00 to 15]
Set the level of reduction in detail in dark parts.
This is only enabled when [DETAIL] is set to [On].
Factory settings: 8
DARK DETAIL SWITCH [Off, On]
Set On/Off for the control that adds detail in dark parts.
This is only enabled when [DETAIL] is set to [On].
Factory settings: Off
DARK DETAIL [0 to 7]
Set the level of detail in dark parts.
Factory settings: 2
SKIN TONE DETAIL [Off, On]
This function smooths skin and produces a more beautiful image.
Set On/Off for the skin tone detail function.
Factory settings: Off
MEMORY SELECT [Off, On]
Select the skin tone table of the subject for the skin tone effect.
Factory settings: Off
ZEBRA [Off, On]
Set On/Off for the zebra display of the skin tone area.
The zebra pattern is displayed only on devices connected to the
3G SDI OUT2/PM connector.
Factory settings: Off
<NOTE>
• This cannot be set when [ZEBRA] in [SKIN TONE DETAIL
SETTING] is [On].
ZEBRA EFFECT MEMORY
[A, B, C, A+B, A+C, B+C, A+B+C]
Select the skin tone table for the zebra display.
Factory settings: A+B+C
SKIN TONE EFFECT MEMORY
[A, B, C, A+B, A+C, B+C, A+B+C]
Select the skin tone table for the skin tone effect.
Factory settings: A+B+C
SKIN TONE CRISP [0 to 8]
Adjust the skin tone detail.
Factory settings: 8
I CENTER [000 to 255]
Set the central position above the I axis (area where skin tone is to
take effect).
Factory settings: 65
I WIDTH [000 to 255]
Set the width of the area where the skin tone is to take effect above
the I axis, centered on [I CENTER].
Factory settings: 63
Q WIDTH [000 to 127]
Set the width of the area where the skin tone is to take effect above
the Q axis, centered on [I CENTER].
Factory settings: 32
Q PHASE [0 to 359]
Set the phase of the area where skin tone is to take effect based on
the Q axis.
Factory settings: 90
155
Advertisement
Table of Contents
