Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual page 118

Web screen configurations (continued)
Fall Acceleration [1 to 255]
Sets the deceleration speed for pan/tilt deceleration operation in 255
steps. (The deceleration speed increases as the number increases.)
When it is necessary to reduce the speed to the specified speed
using manual control of pan/tilt by lever operation etc. through the
controller, the deceleration process is performed based on the
deceleration speed specified in this setting.
This is enabled only when [P/T Acceleration] is [Manual].
Factory settings: 128
<NOTE>
• The deceleration and stop processes are carried out right up to
the end of the lens mechanism section and in order to prevent
a collision with the mechanism, in the actual operation, [Fall
Acceleration] may be restricted.
Speed With Zoom Position [Off, On]
[Off] or [On] is set here for the function used to adjust the pan/tilt
adjustment speed in conjunction with the zoom magnification.
When [On] is set, the panning and tilting operations will become
slower in the zoom status.
This function has no effect during preset operations.
Factory settings: On
Focus Adjust With PTZ. [Off, On]
[Off] or [On] is set here for the function which compensates for out-of-
focusing when it occurs during panning, tilting or zooming operations.
When [Off] is set, adjust the focus as required after zooming or set
[Focus Mode] to [Auto].
This is only enabled when [Manual] has been selected as the [Focus
Mode] setting.
Factory settings: Off
Privacy Mode [Off, On]
Sets Off/On the function for turning the camera direction down when
this unit is changed to Standby mode.
Off Does not change the camera direction when the camera
is switched to Standby mode. (The camera direction from
the Power On state is maintained)
On Moves the camera to face toward the rear when the
camera is switched to Standby mode.
When the unit switches again to the Power On state,
the unit moves to the position according to [Power On
Position].
Factory settings: Off
Power On Position [None, Standby, Home, Preset]
Select the initial positions for Pan/Tilt/Zoom when the power is turned
on.
None Maintains the Pan/Tilt position when the power is turned
on, and Zoom will be at the Wide end.
Standby Move to the Pan/Tilt/Zoom positions they were in the last
time the camera was switched to Standby mode.
Home Pan/Tilt move to their home positions (front) and Zoom
goes to the Wide end.
Preset Preset playback is performed at the preset position
specified with [Preset Number].
Factory settings: Standby
Preset Number [Preset001 to Preset100]
Specify a number for preset playback when the power turns ON when
[Preset] is set in [Power On Position].
Factory settings: Preset001
<NOTE>
• If an unregistered preset number is set, preset playback is not
performed and the operation is the same as [Standby].
„
Date & time screen [Date&Time]
Make clock settings.
You can set using one of three types [PC Synchronization], [NTP], or
[Manual].
The setting is confirmed with the [Set] button.
Auto
PC Synchronization
If you click the [Execute] button, the settings are configured by
synchronizing the unit to the date and time of the connected personal
computer.
<NOTE>
• The time zone of the personal computer is not reflected on the unit.
Set the time zone on the unit.
NTP
If you click [NTP>>], the settings screen for the NTP server appears.
(→ page 172)
Manual
Date/Time
Configure the settings for the month, day, and year and for the hour,
minute, and second.
<NOTE>
• The time is in the 24-hour format.
Time Zone
Selects the time zone according to the region where the camera is
being used.
Factory settings:
(GMT) Greenwich Mean Time : Dublin, Edinburgh, Lisbon, London
118