Table of Contents
Advertisement
Web screen configurations (continued)
System name
Enter the device name used to manage this unit using SNMP
functionality.
Maximum number
0 to 32 characters
of characters
Characters that
Double-byte
cannot be entered
Location
Sets the location where this unit has been installed.
Maximum number
0 to 32 characters
of characters
Characters that
Double-byte
cannot be entered
Contact
Enter the email address or phone number of the administrator.
Maximum number
0 to 255 characters
of characters
Characters that
Double-byte
cannot be entered
z TSL5.0
Make settings related to TSL protocol version 5.0. Set the information
required to control the tallies of this unit from a device that supports the
TSL5.0 protocol with the TSL5.0 function.
The setting is confirmed with the [Set] button.
Index number [1 to 65534]
By matching the INDEX set on the TSL5.0 control device and the
Index number of this unit, you can control the tallies of this unit
individually.
Factory settings: 1
TSL5.0 Port [1 to 65535]
Sets the port number that will receive controls via the TSL 5.0
protocol.
Factory settings: 62000
z Referrer check
By enabling Referrer check, you can confirm that the device requesting
access to the camera is legitimate.
Access is refused if it is determined that the device attempting access is
unauthorized.
Depending on the environment in which the unit is being used, it may
not be possible to access the unit when Referrer check is enabled.
If this occurs, you can access the unit by disabling Referrer check, but
you will no longer be able to determine if the device attempting access is
unauthorized.
Enable
The Referrer check function is used.
Disable
The Referrer check function is not used.
Factory settings: Enable
176
Advertisement
Table of Contents
