Changing Your Network Settings; Using The Network Setup Wizard - Watchguard Firebox X15 User Manual

Changing Your
CHAPTER 5
Network Settings
A primary component of the WatchGuard® Firebox® X Edge setup is
the configuration of the network interface IP addresses. At a minimum,
you must configure the external network and the trusted network to
let traffic flow through the Edge. You do this when you use the Quick
Setup Wizard after you install the Edge. You can use the procedures in
this chapter to change this configuration after you run the Quick Setup
Wizard.
You can also set up the optional interface. Many customers use the
optional network for public servers. An example of a public server is a
Web server.

Using the Network Setup Wizard

The easiest method to change the network IP addresses of the Firebox®
X Edge is with the Network Setup Wizard.
1 To connect to the System Status page, type https:// in the
browser address bar, followed by the IP address of the Edge trusted
interface.
The default URL is: https://192.168.111.1
2
From the navigation bar, select Wizards.
3
Adjacent to Setup the primary network interfaces of the Firebox
X Edge, click Go.
User Guide 59