CHAPTER 6
Wireless Setup
Wireless networks use RF (radio frequency) signals to send and receive
traffic from computers. The Firebox® X Edge Wireless protects the
computers that are connected to your network and it protects your
network wireless connections. The Firebox® X Edge Wireless obeys the
802.11b and 802.11g guidelines set by the Institute of Electrical and
Electronics Engineers (IEEE). This chapter examines how to install the
Firebox X Edge Wireless and set up the wireless network.
By default, the wireless features of your Firebox are disabled for more
security. You must enable the wireless feature after you complete the
Firebox X Edge Wireless Quick Setup wizard.
To install the Firebox X Edge Wireless:
•
Identify and record your TCP/IP settings
•
Disable the HTTP Proxy settings of your Web browser
•
Activate DHCP on your computer
•
Make a physical Ethernet connection between the Firebox X Edge
Wireless and your network. You must connect to the Edge with a
wired connection to configure its wireless properties.
•
Attach the two antennae to the Firebox X Edge Wireless.
•
Install the Firebox X Edge Wireless in a location more than 20
centimeters from all persons. This is an FCC requirement for low
power transmitters.
User Guide
Firebox X Edge
89