Enabling Muvpn For Edge Users; Configuring Muvpn Client Settings - Watchguard Firebox X15 User Manual

Wireless Network" on page 213 for information about how to
make the wireless computers use MUVPN on the Edge's wireless
network.
• If you want to use a Pocket PC device to make a VPN
connection to the Edge, see "Tips for Configuring the Pocket
PC" on page 214.
• At the end of this chapter is a section with troubleshooting tips.

Enabling MUVPN for Edge Users

Before you configure the MUVPN client, you must configure
MUVPN client and user settings on the Firebox® X Edge.

Configuring MUVPN client settings

Some MUVPN client settings apply to all of the Edge's MUVPN con-
nections. Select Firebox Users > Settings to set these options:
• To make the .wgx file read-only so that the user cannot change
the security policy file by default, select the Make the MUVPN
client security policy read-only check box.
• Set how the virtual adapter operates on the client (Disabled,
Preferred, or Required). The remote MUVPN computers can use
a virtual adapter to get network settings, an IP address, and
WINS and DNS address assignments. You can set the virtual
adapter rule for your mobile users to:
Disabled
The mobile user does not use a virtual adapter to connect with
the MUVPN client. This is the default setting. With the virtual
adapter disabled, the MUVPN client is not assigned a WINS or
DNS address. Because of this, the computer must have correct
WINS and DNS addresses configured in the primary network card
settings. See the section "Preparing Remote Computers for
MUVPN" on page 197 for information on entering WINS and
DNS addresses in the network card advanced settings.
User Guide
Enabling MUVPN for Edge Users
193