Adding A Custom Incoming Service Manually - Watchguard Firebox X15 User Manual

Configuring Firewall Settings
Protocols and Ports
Set the protocol and ports to assign to this traffic filter.
Traffic Direction
Identify if this is an incoming or outgoing service.
Service action
Configures the Firebox to allow or deny this type of service
traffic through the firewall.
Restrict to remote computers
To put a limit on the scope of the service, add the IP addresses
of the computers or networks outside the firewall to which this
service applies.
Restrict to local computers
To put a limit on the scope of the service, add the IP addresses
of the computers or networks inside the firewall to which this
service applies.

Adding a custom incoming service manually

You can add a custom service without using the wizard.
1 To connect to the System Status page, type https:// in the
browser address bar, and the IP address of the Edge trusted
interface.
The default URL is: https://192.168.111.1
2
From the navigation bar, select Firewall > Incoming.
The Filter Incoming Traffic page appears.
3 Scroll to the bottom of the page.
4
Below Custom Services, click Add Service.
The Custom Service page appears.
108 WatchGuard Firebox X Edge