Windows 2000 Setup - Watchguard Firebox X15 User Manual

Configuring the MUVPN Client
9
Click Yes to restart the computer.
The computer restarts and your settings are applied.

Windows 2000 setup

Use this section to install and configure the network components
for the Windows 2000 operating system. These components must be
installed before you can use the MUVPN client on a Windows 2000
computer.
From the Windows desktop:
1
Select Start > Settings > Network and Dial-up Connections.
2
Right-click the connection you use to get Internet access and
select Properties.
The connection properties window appears.
3
Click the Networking tab.
4
Make sure these components are installed and enabled:
To enable a component, click the adjacent check box. If a component is
not installed, follow the instructions to install it.
- Internet Protocol (TCP/IP)
- File and Printer Sharing for Microsoft Networks
- Client for Microsoft Networks
Installing the Internet Protocol (TCP/IP) network
component
From the connection window Networking tab:
1
Click Install.
The Select Network Component Type window appears.
2
Double-click the Protocol network component.
The Select Network Protocol window appears.
3
Below the Microsoft manufacturer, select the Internet Protocol
(TCP/IP) network protocol and click OK.
Installing the File and Printer Sharing for Microsoft
Networks
From the connection window Networking tab:
1
Click Install.
The Select Network Component Type window appears.
2
Double-click the Services network component.
The Select Network Service window appears.
200 WatchGuard Firebox X Edge