Table of Contents
Advertisement
29
Fig. Control panel:
29. Warning lights panel;
26. Throttle lever;
12. Parking brake;
Fig. Engine compartment:
20. Master switch.
34
Fig. Machine:
34. Chocks.
01-06-2022
Switching off
Check the controls and warning lights to see if any faults
are indicated (29). Switch off all lights and other electrical
functions.
Set Speed selector (26) in low idle position and let the
engine run for about one minute.
26
12
Activate the parking brake (12).
Turn the ignition key to the left to the switched off position
(1). At the end of the shift. Lower down and lock the control
panel cover.
20
Parking of the machine
Master switch
Switch the master switch (20) into disconnected mode
and remove the key at the end of the shift. This will
prevent battery discharging and will also make it difficult
for unauthorised persons to start and operate the
machine. Also lock the engine hood with the key.
Chocking the drums
4812134740EN
Never leave the machine when the is engine
running, without pressing the emergency or
parking brake button first.
Make sure that the machine is parked in a safe
place with respect to other people who pass
through the place. Chock the drums if the roller
is parked on sloping ground.
Remember the risk of freezing during the winter. Fill
the engine cooling system and the screen wash
bottle of the cab windshields, tyres with suitable
anti- freeze mixtures. See maintenance instructions
as well.
Operation – Stopping
68
Advertisement
Table of Contents
