Table of Contents
Advertisement
Fig. Control panel:
3.
Vibration switch;
5.
Forward/reverse lever;
2
Fig. Control panel:
2.
Emergency stop;
12.
Parking brake
2
Fig. Control panel:
3.
Emergency stop;
12.
Parking brake
01-06-2022
Operation – Stopping
Braking
Service brake
Press the switch (3) to switch off the vibration.
Place the forward/reverse lever (5) to neutral position to
stop the machine.
Set Throttle control to idle running position.
3
Set the parking brake switch in the 'ON' position.
5
Reserve brake
Braking is normally activated using the forward/reverse
lever. The hydrostatic transmission retards and slows the
roller when the lever is moved towards the neutral position.
There is also a brake in the Drum motor, gear box and rear
axle of the machine that acts as an emergency brake
during operation.
12
Emergency stop
The emergency stop is activated by pressing the button
(2).
.
Hold the steering wheel firmly and brace yourself for
sudden stop.
12
The brake is applied and the engine stops.
After an emergency stop, return the forward/reverse lever
to neutral and deactivate the emergency stop by pulling up
the button (2).
Activate the parking brake (12) and the engine can be
restarted.
4812134740EN
Operation – Stopping
Always use the parking brake when the machine
is stationary on a sloping surface.
When starting and driving a machine that is
cold, remember that the hydraulic fluid is also
cold and that braking distances can be longer
than normal until the machine reaches the
working temperature.
For reserve braking, press the parking bake
button (12), hold the steering wheel firmly and
be prepared for a sudden stop. The brakes are
applied and the engine stops.
67
Advertisement
Table of Contents
