Vivitek DU9057Z User Manual page 51

DLP Projector - User Manual
options are REC709, EBU SMPTE and Native.
Color Temperature: The default of color temperature is Native, and it is suitable for most situations. As color
temperature rises, the picture will appear bluer, while as the color temperature decreases, the picture will
appear redder. The available options are Native, 3200K, 5400K, 6500K, 7500K and 9300K
Input Balance: When ambient light is too bright or changes, the projected image details may be affected, you
can adjust the option to make the projected colors of image closer to desired colors. There are two options for
fine tuning Red, Green and Blue
Gain: These three options are used to increase or decrease the range of color input for the entire image. If
minimal amount of red, green or blue appears in the gray areas, lower the gain of the corresponding color
accordingly. As gain increases, the contrast of the image will become lower.
Offset: These three options will shift the color spectrum for the whole image and change its brightness, if
minimal amount of red, green or blue appears in the gray areas, you can adjust the offset of the
corresponding color accordingly. By increasing the offset, the image brightness will become lower.
Reset: All the settings toward Input Balance will set to default.
Uniformity
Mode: Enable Color uniformity correction.
Location X: Select the block area from X axis.
Location Y: Select the block area from Y axis.
Red Gain: Adjust the Red color gain on the selected block area
Green Gain: Adjust the Green color gain on the selected block area
Blue Gain: Adjust the Blue color gain on the selected block area
Reset: All the settings toward Uniformity will set to default.
HDR
Press ◄/► to select a suitable HDR setting. The options are Off, Auto, PQ-400, PQ-500, PQ-1000 and HLG.
Visual Color Effects
On: Reduce visual color effect with normal noise.
Off: Normally visual color effect with lower noise.
UM90570802EN00
50