Vivitek DU9057Z User Manual page 33

DLP Projector - User Manual
Set the identification number of remote control
Press and hold ID SET button on the remote control around 5 seconds, Power LED indicator is flashing red
periodically. Press two digits to set desired ID number, each pressing shall be leisurely. Power LED will flash on
time when the remote control is confirmed the setting.
Press and Hold ID SET button
around 5 seconds
Note:
Setting the identification number will overwrite the ID number you had set. You can set the ID
number directly if you would like to give a new ID number for the remote control.
Erase the identification number of the remote control
The set ID number is overwritten if new ID number is set, you can press ID SET and CLEAR button to erase ID
number of the remote control.
Press ID SET and CLEAR buttons simultaneously
Note:
 Project ID Control function is available when the option is turned on and remote control wire is
not plugged into the wire remote jack port.
 If ID Control Enable is set to Off, the projector can receive any control signal from the remote
control. Even if the ID number is set into the remote control.
UM90570802EN00
Power LED is flashing
The backlight of the buttons is flashing one time
32
Press two digits for ID number