Connecting To A Control Equipment - Vivitek DU9057Z User Manual

DLP Projector - User Manual

Connecting to a Control Equipment

The projector has the following control port for connecting to the control equipment:
HDBaseT/LAN (Network control): The projector supports network control. LAN and HDBaseT share the same port.
If only network control is used, you can connect the LAN on the projector to PC or through the local network.
Refer to the Remote Communication Manual for detailed information.
RS-232 (RS-232 control): The projector can be remote-controlled by connecting the projector to a PC or control
system through the standard 9-pin serial cable (Straight Through Serial Cable). Refer to the Remote
Communication Manual for detailed information.
Wired remote control: If the projector cannot receive the IR signal from the remote control due to the overly long
distance or obstacles, you can connect the cable to the IR remote control or the external IR transmitter (optional)
via the WIRE input port to expand the working range of the remote control.
Sync Out/In: Connect to 3D IR sync signal transmitter or device.
3D SYNC IR: Connect 3D IR glasses receiver unit.
Note:
 When the terminal of the remote control cable is inserted to the wired control terminal of the
projector, the projector will automatically switch to the wired control mode and cannot be controlled
through the IR signal of the remote control. Disconnect the wired control terminal on the projector if
you want to control through the IR signal of the remote control.
 If the wired remote control cable or the external IR transmitter is inserted to the incorrect port such
as Trigger, the remote control or the IR transmitter may be damaged. Make sure whether the port is
correct.
UM90570802EN00
35