Table of Contents
Advertisement
DLP Projector - User Manual
Wired Remote Jack
Connect to WIRED REMOTE
terminal on the projector
Remote Control Operating Range
The remote control uses the infrared transmission to control the projector. It is not necessary to point the remote
directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the
projector, the remote will function well within a radius of about 10 meters (25 feet) and 15 degrees above or below
the projector level. If the projector does not respond to the remote control, move a little closer.
UM90570802EN00
3G-SDI
Select 12G SDI as the input source.
DisplayPort
NA.
HDBaseT
Select HDBaseT the input source.
CLEAR
Erase the set ID number of the remote control; refer to the section
"Using Control ID for Multi-projector Application".
FREEZE
Freeze the projected image or resume the projection.
ID SET
Set up ID number for remote control; refer to the section "Using
Control ID for Multi-projector Application".
±15°
15
Advertisement
Table of Contents
