DLP Projector - User Manual
Using Control ID for Multi-Projector Application
When installing more than one projector in the room, the projectors may receive the control signal at the same
time. In this case, you can use control ID function to specify the identification of the projector and remote control
to operate the specified projector. Follow the below steps to set up the identification number for the projector and
remote control.
Set the Projector identification number
1. Enable Projector ID Control function from CONTROL->Infrared Remote as below figure.
2. Set IR Code
Select IR Code option then press Enter button, use the ► button to increase the number or the ◄ button to
decrease the number.
UM90570802EN00
31