Connecting An Hdbaset Transmitter - Vivitek DU9057Z User Manual

DLP Projector - User Manual

Connecting an HDBaseT Transmitter

The projector has a built-in HDBaseT receiver. With an HDBaseT Transmitter (optional), the video, RS-232 and
LAN signals can be sent to the projector via a single RJ-45 cable. If the HDBaseT Transmitter you purchased
supports the input and output of the IR remote control, the control signals from the IR remote control can be sent
to the DU9057Z projector via the RJ-45 cable.
Control P C
Note:
 The projector supports the video signal, R-232, IR remote control and the reception of the network
control signals but do not support Power over Ethernet (PoE).
 The baud rate will be switched to 9600 automatically. If RS232 command is sent via external
HDBaseT transmitter.
 If the command is sent via the HDBaseT transmitter, the longest transmission distance is 100
meters. If the transmission distance exceeds 100 meters, there is a possibility that the projection
may be interrupted, or the control signal cannot be sent.
 Use the RJ-45 Cat5e or above cable and avoid entwining. Entwining may cause damage or signal
transmission interference, thus reducing the transmission distance and degrading the image quality.
UM90570802EN00
VGA Ca ble
Hub
Control P C
DVD P la ye r DVD P la ye r
YP b P r RJ 4 5 HDMI
La n
RS -232c
37
RS 2 3 2 RJ 4 5
HDBa s e T