Osd Menu - Input - Vivitek DU9057Z User Manual

DLP Projector - User Manual
OSD Menu – INPUT
Input Selection
Use the shortcut key on the remote control or this function to select the input source. The Input options are as
below.
The available input source of the product is HDMI 1, HDMI 2, HDBaseT, DVI and SDI.
Resync
To automatically synchronize the projector to the input source.
HDMI Equalizer
Sets a suitable value to maintain the HDMI picture quality in long distance data transmission.
Color Space
This function allows you to change the corresponding color space for the input signal in most cases, the default is
Auto.
Auto: The projector detects the input signal and switches to the corresponding color space automatically.
YPbPr: Set the color space to ITU-R BT 601.
YCbCr: Set the color space to ITU-R BT 709.
RGB-PC: Use the RGB color space and set the black to 0, 0, 0 RGB, while set the white to 255, 255, 255 RGB (if
an 8-bit image is used).
RGB-Video: Use the RGB color space and set the black to 16, 16, 16 RGB while set the white to 235, 235, 235 (if
an 8-bit image is used) to correspond to the luminance value defined in the digital component standard.
Constant Input
Auto Switching: Enable auto-switch input source between HDMI1/2.
EDID Mode
Press ENTER, and use the ◄ or ► buttons to select a EDID mode of HDMI1\2\DVT and HDBaseT.
Note:
HDMI1/2 default EDID mode is 4K/60. But for some equipments , EDID mode is needed to select
4K/30 to catch the input signal normally.
UM90570802EN00
46