DLP Projector - User Manual
Connecting to AC Power Supply
The AC power cord is included in the box; plug the power cord to the AC socket on the IO panel.
Important:
When the input voltage is 110V, the current supplied by the power supply does not provide the
current required to run the projector at full power. In this case, the projector will automatically reduce
the light source power to 65%, and the projector light output will also be reduced to about 65% of the
nominal brightness accordingly to ensure that the projector can operate normally
Turning On the Projector
Once the projector is correctly located and the power cable and other connections are in place, it is important that
the projector is powered on correctly in order to avoid damage to components and un-necessary wear and tear.
Refer to the following guide to power on the projector.
1.
Press the main power switch to the on ( I ) position
as shown. POWER LEDs will flash, then turn a solid
red.
2. Press the POWER button on the control panel or ON
button on the remote control.
3. The Power LED and LIGHT LED flashes green until
the power on process is finished.
4. After a few seconds, both LEDs lights will become a
solid green to indicate the projector is ready for use.
UM90570802EN00
21