Table of Contents
Advertisement
DLP Projector - User Manual
Noise Reduction
Use ◄► to adjust the noise of the projected image. This function is used to remove the noise of the image with
interlaced scanning input. Generally, noise reduction can lower the high-frequency details and make the image
softer.
Output Frame Rate
Use ◄► to select the output frame frequency.
Note:
Will be grayed-out when 3D mode and force run in Auto option.
3D
This function is to set the 3D format and sync method. The projector detects the type of input signals and
provides relevant options for settings. Before performing 3D setting, make sure that the input signal is connected.
DLP Link: This function is to activate or deactivate the DLP Link sync.
3D Format:
Off: Turn off the 3D Display Mode. When Auto, Side by Side, Top and Bottom, or Frame Sequential is
selected, the 3D Mode will be turned on. To turn off the 3D Mode, select "Off" and press "ENTER".
Auto: Allow the 3D format to automatically detect the formats of Frame Packing, Top and Bottom, and Side
by Side. The input signal is HDMI 1.4b 3D.
Side by Side (Half): This option is only applicable to input signal HDMI 1.4b 3D or HDMI signal sent by
HDBaseT Transmitter.
Top and Bottom: This option is only applicable to input signal HDMI 1.4b 3D or HDMI signal sent by
HDBaseT Transmitter.
Dual Channel: Display 3D by HDMI1 and HDMI2 with L / R.
Frame Sequential: Set input format under Frame Sequential.
Frame Packing: Set input format under Frame Packing.
Eye Swap: If the 3D image transmitted to the 3D glasses is reverse, you can set the Eye Swap to "Reverse" to
normalize the image. Otherwise, keeping mode of "Normal" would be suggested.
Dark Time: Manually switch the Dark time for glasses tolerance, the available options are 0.65ms, 1.3ms and
1.95ms.
Sync Delay: If the 3D display shutter switch time of different brand 3D product is not synchronized with the
projector, it will cause ghosting or poor 3D effect. Please adjust the sync delay to synchronize the 3D machine
shutter and the projector shutter switching time for the best 3D projection.
Sync Reference: The projector provides DLP Link and 3D IR sync for 3D display, the projector will automatically
set the sync signal depended on the 3D format and if the external 3D sync device is connected.
This function is only applied to the condition that 3D Format is Frame Sequential or external 3D sync device is
connected to the projector.
External: Signal is sent from external 3D sync signal receiver.
nternal:
I
Signal is sent by the projector, 3D sync signal is DLP Link.
Important reminders:
People with the following conditions should view 3D image with great care:
Children under six years in age
◼
People who are sensitive to light or allergic to light, unhealthy and have a history of
◼
cardiovascular diseases.
People who are tired or lack of sleep
◼
People who are under the impact of drugs or alcohol
◼
Normally, it is safe to watch 3D images. However, some people might feel uncomfortable.
◼
Refer to the guidelines that were revised and released by the 3D League on December 10,
2008. It states that those who watch 3D images, need to take a break for at least 5 to 15
UM90570802EN00
47
Advertisement
Table of Contents
