DLP Projector - User Manual
IO Panel
SYNC IN / OUT
Connect 3D-sync in cable from a computer or an
enabled device.
HDMI 1 / 2
Connect the HDMI cable from a computer or video
device
HDBaseT
Connect the HDBaseT Transmitter.
TRIGGER (12V +/-1.5V)
When connected to the screen through a 3.5mm
cable, the screen deploys automatically on startup of
the projector. The screen reacts when the projector
is powered off.
USB 5V-2A
Connect a USB cable for USB host.
Note: Support 5V/2A output as long as the projector
Power On.
Note for Trigger
When the projector is turned on, a control output signal (DC 12V) is delivered from this terminal.
Do not use this jack for anything other than intended use.
Note for Wired Remote
Please make sure whether the port for insertion is correct before the terminal of the wired remote
control is inserted. The remote control may be damaged if inserted to the wrong port such as trigger.
Do not use this jack for anything other than intended use.
UM90570802EN00
RS-232
The 9-pin D-sub interface is used to connect to the
PC control system and projector maintenance.
DVI-D
Connect to DVI-D cable from a DVI-D output of the
device.
3D SYNC IR
Connect 3D IR glasses receiver unit.
SDI IN/OUT
Connect to 12G SDI source.
Ethernet / Art-Net
Connect an Ethernet cable (Cat5/Cat6, not supplied)
from a computer, network device.
WIRED REMOTE IN / OUT
Connect the supplied remote controller to the
projector
12