Table of Contents
Advertisement
DLP Projector - User Manual
Instant Startup
Enable instant startup function.
Standby Period
Setting instant startup period time. Available when instant startup is On.
Network
Use this function to configure the network settings, so that you can control the projector via the network. Press
the ▲ or ▼ button and Enter button to select Network and network settings. Please refer to Remote
Communication Manual for further information.
Network Setup
DHCP: Set DHCP to ON/OFF. When DHCP is set to ON, the DHCP server of the domain will assign an IP
address to the projector. The IP address will appear on the IP address window without need to make any
input. If the domain cannot assign any IP address, 0.0.0.0 will be shown on the IP address window.
IP Address: To specify an IP address, press the Enter button to show the IP address input window. Use the
◄ or ► button to select the number in the address to change. Use the ▲ or ▼ button to increase or
decrease the number in the IP address. Network IP Address 172. xxx. xxx. xxx.
Subnet Mask: Set the subnet mask. The input method is the same as the setting for IP address.
Gateway: Set the gateway. The input method is the same as the setting for IP address.
DNS: Set the DNS. The input method is the same as the setting for IP address.
MAC Address: Shows the projector's MAC Address.
Apply: Apply the settings.
Art-Net Setup: Setup the settings of Art-Net.
Art-Net Channel Setting: Set function mapping for each channel of Art-Net.
Art-Net Channel Status: Shows current channel function mapping of Art-Net.
Rental Mode
Press ENTER and use ▲ or ▼ to scroll through submenus and enter 5 digits password.
Power Locked Level: Press ENTER and use ▲ or ▼ to scroll through submenus
Power Locked Level: To select fixed power level output ??60??00??
Power Locked Level Reset: To reset power level output to default.
Usage Locked Time: Press ENTER and use ▲ or ▼ to scroll through submenus
Usage Locked Time: To select Disable / Enable usage locked time.
Usage Time Setting(HRS): Set the usage time. There will jump out a caution window when time run out.
Expiration Time Reset: To restart and countdown the expiration time.
Change Password: Press ENTER to change the password of Rental Mode.
Note:
If want to enable Rental Mode, please contact local agent to obtain 5 digits password.
UM90570802EN00
58
Advertisement
Table of Contents
