How To Move Marquee To Top Of Game - Bay-Tek CONNECT 4 HOOPS Service Manual

HOW TO MOVE MARQUEE TO TOP OF GAME

If you have at least 9 inches of clearance above your game, the round marquee may be installed on
top of the game. This is a matter of personal preference:
Standard mounting under the roof
Tools needed:
7/16" Wrench
Instructions:
Using 2 people, carefully climb up into the cabinet and remove the 8
nut and bolts attaching the marquee to the game using a Phillips
screwdriver and 7/16" wrench.
Unplug the 2 pin connector, and set on the floor.
On yellow side - Remove the 4 bolts using a Phillips screwdriver.
Rotate the bracket 180 degrees and re-install,
On red side - Remove the 4 bolts using a Phillips
screwdriver.
Pull the cable from the center of the support, it will be
moved to under the bracket, against the marquee.
Remove the support bracket.
If there is no channel to route wire, uses a spade drill bit to create a channel
so the wires do not get pinched.
Route wires as shown.
Rotate the bracket 180 degrees and re-install.
Using 2 people, carefully bring the marquee back up onto the top of the game and re-install the
bolts, washers, and nuts. Make sure these are all tightened completely. Plug in the power connector.
Installation is complete.
Phillips Screwdriver
Optional mounting on top
2 people
from this
to this.
52