Bay-Tek CONNECT 4 HOOPS Service Manual page 19

CONNECT 4 HOOPS HD SETUP
Option B: Mounting on top of game
The brackets will have to be flipped on the marquee.
Remove the circular marquee from Box # 2. Lay on floor as shown.
On yellow side - Remove the 4 bolts using a Phillips screwdriver.
Rotate the bracket 180 degrees and re-install,
On red side - Remove the 4 bolts using a Phillips
screwdriver.
Pull the cable from the center of the support, it will be
moved to under the bracket, against the marquee.
Remove the support bracket.
Route wires in the channel so the wires do not get pinched. as shown.
Rotate the bracket 180 degrees and re-install.
Install circular marquee:
Using 2 people, stand the assembly upright on the floor in
front of the game.
Be sure the white plastic is facing out into the game room.
Ensure the red artwork in on the left side.
Using 3 people, lift the circular marquee up into position on
top of the front section.
Secure marquee onto assembly using 8 of ¼-20 X 1 1/2" Phillips head bolts
using a # 3 Phillips Head bit into each support bracket.
(4 per side)
Place a bolt with flat washer up into the
wood, through metal bracket,
Secure with a 1/4" split washer and 1/4" nut
bolt and
tighten using a 7/16" wrench.
Repeat process for other support bracket.
from this
to this.
A5BOPH320
A5WASI020
19
A5WAFL060
onto
A5NULO050