Bay-Tek CONNECT 4 HOOPS Service Manual page 20

CONNECT 4 HOOPS HD SETUP
Continuing Assembly with either option:
Plug in the marquee power cable to the cable on
the top left side of assembly.
There is also a coiled cable there that will be used
later in the installation.
Using 3 people, carefully lift the marquee on top of the front cabinet.
The left side will have 2 cables that will feed down into the lower
front cabinet.
The right side will have 1 cable that will feed down into the lower
front cabinet.
As the marquee assembly is lifted up,
feed these cables down into the holes on
both left and right sides.
Locate the 2 of metal front connector plates. Part 4 from box # 2.
Install the plates on both sides of the cabinet with 8 of the black
¼-20 X 1 Phillips head bolts using a # 3 Phillips Head bit.
(4 per side)
Install 16 of 1¼" black bugle screws using a # 2 Square
Head bit to secure the white and black plastic to the lower
cabinet on both sides.
(8 per side)
A5WALO010
A5BOPH312
20
4