Bay-Tek CONNECT 4 HOOPS Service Manual page 21

CONNECT 4 HOOPS HD SETUP
Using a 6 foot ladder, install 2 of the black ¼-20 X 1
Phillips head bolts using a # 3 Phillips Head bit on the
top front end of cage. This will secure the cage to the
front marquee.
Repeat on other side.
Locate the coiled cable in the front left roof of the cabinet.
Snip plastic wire ties holding cables carefully to avoid cutting wires.
Stretch this cable to the rear left corner of the game to plug
into the rear lights cable part # AALB15044
Open the left red coin door and connect the 2 cables from marquee:
2 pin connector CE15005 to CE15006
4 pin connector CE15039 to CE15007
Open the right yellow coin door and connect the 1 cable from marquee:
4 pin connector CE15039 to CE15009
Locate the Clear Acrylic ball guard from box # 1.
Remove the protective paper from both sides of the Acrylic plexi.
The flat edge bottom of the plexi will fit into the
groove between the white plastic and wood lip.
Slide acrylic plexi down in between the black plastic
pieces into this groove.
The plexi shield is held in place by gravity.
Power on game:
Open the front middle door, and ensure the USB cable
from the rear controller board is plugged into any of the
USB slots on the motherboard.
Turn on rocker switch on the power strip.
The game is now set up and ready for play!
Enter menu to adjust settings to your location specific price per play and ticket payout.
A5BOPH312
21