Bay-Tek CONNECT 4 HOOPS Service Manual page 42

TROUBLESHOOTING GUIDE
Problem
If all colored cabinet lights
One of the right
are not functioning, check
side, yellow
power into the Control
colored LED
Board from the Power
strips
Distribution Board.
not working
If single LED strip is out,
LED's receive 12
check cable. LED's are
Volts DC from
wired in series. Refer to
Control Board in
wiring diagram.
the rear of the
game.
Faulty LED
Refer to "How to
Access Rear
Control Board"
Ensure Control Board is
LED color strip
receiving voltage from
under the hoops
Power Distribution Board.
are not working
LED's receive
Faulty LED
voltage from
Control Board in
the rear of the
game.
Swap connectors at the 2
buttons.
Menu Buttons do
not work. Pinched, broken, or
disconnected wiring
I/O Aux board faulty.
Tickets are empty in ticket tray
Low Tickets
message on
Faulty cable. Disconnected,
monitor
loose or broken wires.
Faulty low ticket switch.
Faulty I/O Aux Board.
Probable Cause
Load tickets into tray. Ensure tickets hold down micro
switch wire.
Check connectors from low ticket switches to Newgen
board. Check for continuity. (AACE10014 or AACE10015)
Inspect switch and replace if needed. (AASW200)
Swap I/O Aux board with other player side, making sure to
change dipswitch settings.
dip 1 is on, 2 is off) Replace I/O Aux Board.
Part # AACB9604
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board in the front of the
cabinet to Control Board in the back.
Cables # AACE15017, AACE15016, and AACE15015
Check for 12 volts coming from Power Distribution Board
in the rear of the cabinet on red and black wires.
If no 12 volts DC, ensure 12 volts is coming into board on
cable # AACE15018. If voltage is present - replace
Control Board part # AACB10000
Refer to wiring diagram. Cables # AACE15018,
AACE15019, AACE15020, AALB15042, AACE15007,
AACE15040, AACE15039, and AACE15041
Swap LED connector from one socket to the other to
verify. Replace LED as needed.
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board in the front of the
cabinet to Control Board in the back.
Cables # AACE15017, AACE15016, and AACE15015
Refer to wiring diagram. Cables # AACE15000,
AALB15000 and A5CB15000
Replace button if problem stays with button.(AAPB2700)
Inspect crimp to ensure good connection.
Check connections from menu buttons to left I/O Aux
Board. Check cables (AAPB2700, AACE15010)
Swap I/O Aux board with other player side, making sure
to change dipswitch settings. (Left side both off, Right
side dip 1 is on, 2 is off)
Replace I/O Aux Board. Part # AACB9604
42
Remedy
(Left side both off, Right side