Bay-Tek CONNECT 4 HOOPS Service Manual page 15

CONNECT 4 HOOPS HD SETUP
On the right side, plug the white connectors (CE15022 to CE15023)
and power cords together.
Position the front console up tight against the middle cabinet assembly.
Locate the 2 of the middle connector plates. Part 3 from box # 1.
Install the plates on the side of the cabinet with 16 of the black
¼-20 X 1" Phillips head bolts using a # 3 Phillips Head bit.
(8 per side)
Install bolts loosely, until all are started.
Note: Use crescent wrench to raise the rear section if cabinet sections
do not line up properly.
Tighten all 16 bolts.
Install 3 top roof boards:
Locate the 3 Game Roof Boards (Part G) from box # 1.
These can be brought inside the cabinet and positioned from the inside.
Place each on top of game in the cage channel.
Ensure the T-nuts are facing upward.
Align holes in wood with holes in metal cage.
Install 4 of the black ¼-20 X 1" Phillips head bolts
using a # 3 Phillips Head bit into each roof board.
(2 in each side, 12 total)
A5BOPH312
A5BOPH312
15
3
3
G