Bay-Tek CONNECT 4 HOOPS Service Manual page 41

TROUBLESHOOTING GUIDE
Problem
LED's receive 12 Volts DC
from power supply through
LED white rear
The Power Distribution
cabinet lighting
Board.
above hoops not
working
Faulty LED light.
LED's receive 12 Volts DC
from power supply through
LED white front
The Power Distribution
panel light not
Board.
working
Faulty LED light.
LED's receive 12 Volts DC
from power supply through
Upper marquee
The Power Distribution
LED's not
Board.
working
Faulty LED light.
If all colored cabinet lights
are not functioning, check
One of the left
power into the Control
side, red colored
Board from the Power
LED strips
Distribution Board.
not working
If single LED strip is out,
check cable. LED's are
LED's receive 12
wired in series. Refer to
Volts DC from
wiring diagram.
Control Board in
the rear of the
game.
Faulty LED
Refer to "How to
Access Rear
Control Board"
Probable Cause
Check for proper connection from power supply to Power
Distribution Board.
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board to LED lights.
Cables # AACE15006, AACE15005, AALB15044, and
AALB15045.
Light strips are wired in series. Swap the 2 light strips to
identify a faulty LED strip. Replace as needed. Part #
AALB15044 or AALB15045
Check for proper connection from power supply to Power
Distribution Board.
Refer to wiring diagram. Check connections and reseat
cable from Power Distribution Board to LED lights.
Cables # AACE15003, and AALB15043
Replace Panel Stick Light. Part # AALB15043
Check for proper connection from power supply to Power
Distribution Board.
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board to LED lights.
Cables # AACE15006, AACE15005, and AACE10045
Light strips are wired in series. Swap the 2 light strips to
identify a faulty LED strip. Replace as needed. Part #
AALB15047 or AALB15048
Refer to wiring diagram. Check connections and reseat
cables from Power Distribution Board in the front of the
cabinet to Control Board in the back.
Cables # AACE15017, AACE15016, and AACE15015
Check for 12 volts coming from Power Distribution Board
in the rear of the cabinet on red and black wires.
If no 12 volts DC, ensure 12 volts is coming into board on
cable # AACE15018. If voltage is present - replace
Control Board part # AACB10000
Refer to wiring diagram. Cables # AACE15018,
AACE15019, AACE15020, AALB15042, AACE15007,
AACE15040, AACE15039, and AACE15041
Swap LED connector from one socket to the other to
verify. Replace LED as needed.
41
Remedy