OdaLog® L2 – Gas Logger User Manual
Start Level
"Pre-use" Span Check result (preferred value) when applying test gas before deployment in the field (See
Section 9.8.1). If this value was not recorded, use the Span level that was set during calibration (Cal gas
value – as set in the OdaStat-G™ software).
End Level
"Post-Use" Span Check result that was recorded once logging had finished (see Section 9.8.2).
Tip: Selecting "Suppress Negatives" (See Section 6.13) when applying decay compensation will prevent a
false exaggeration of negative readings.
P/N: 10-1000
Revision G, January 2024
Page | 29