Installing The Monitor - Eizo CuratOR LX491W Instructions For Use Manual

Setup and installation

4.2 Installing the monitor

4.2 Installing the monitor
NOTICE
Holders
• Mounts must be tested and approved by the manufacturer for the weight to be sup-
ported.
• An installed stand must be sufficiently stable to withstand tilting of up to 10° without top-
pling the monitor.
Note
Inaccessible cover
Before installing the monitor in the selected holder, check whether the screws for removing
the cover of the connection panel are accessible. If not, remove the connection panel
cover prior to installation.
The monitor has a VESA 400x200 mounting interface and can be installed in a suitable ceil-
ing suspension or wall mount.
Note the following during installation:
• The maximum torque for attaching to the holder is 10 Nm.
• The screws used for attaching to the holder must meet the following requirements:
No.
Thread
Strength
Insertion depth
16
4
M8
8.8 in accordance with ISO 898-1
10 mm to 30 mm
Instructions for Use, 02/2018
CuratOR LX491W