Installing The Monitor - Eizo FlexScan S2001W Setup Manual

Prior to use
Installation/storage of the monitor with EZ-UP stand
If you have purchased the monitor with EZ-UP stand, please perform the following procedures when installing and
storing.
The stand of the monitor is locked with a lock metal fitting at the packing. Remove the lock metal fitting after placing
the monitor on the desk or the stand may be unfolded suddenly. Keep the lock metal fitting for future movement or
transportation of the monitor.

Installing the monitor

1
Lift the monitor screen in the arrow direction.
Lift it by holding the panel portion with both hands, until you may hear the "click". If it clicks, the monitor
stand lock is surely functioned to use the monitor.
2
Lower the monitor screen position, and remove the lock metal fitting.
Attention
• Removing the lock metal fitting may allow the stand unfolding suddenly.
• Do not use the monitor when the EZ-UP stand is folded.
• After releasing the lock, take care not to catch your fingers when lowering the monitor. This may cause
injury or damage the monitor.
Storage the monitor
1
Remove the cable holder.
2
Lower the monitor screen position until the hinge of the stand touches the stand
base, and attach the lock metal fitting.
Adjust the monitor angle so as the monitor screen not to touch the stand base.
3
Fall the monitor screen backward with keeping slide-up the "Unlock" knob.
When maximally tilting (25º) the monitor screen backward, the "Unlock" knob may be hard to be slid-up.
Then, slightly tilt up the monitor to vertical direction and slide-up the "Unlock" knob.
Installation
2
Hinge
Stand Base
"Unlock" knob
Setting/Adjustment
1
Lock metal fitting
Troubleshooting
3