Table of Contents
Advertisement
40
Maintaining and Troubleshooting Your E-5200 System
Push the new processor into the slot until it snaps into place.
6.
Replace the top bracket and the two screws that hold the bracket in
7.
place.
Set the jumpers on the system board to match your processor speed.
8.
Use the following illustration and tables to set the jumpers. In the
tables, On means place the jumper on the two jumper pins, and Off
means remove the jumper from the two jumper pins.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the E-5200 and is the answer not in the manual?
Questions and answers