Analog Outputs - Grundfos CIM 300 BACnet MS/TP Instructions Manual

Related information
7.7 Tank-filling applications
12. Grundfos alarm and warning codes

6.7 Analog outputs

Object for setting a new setpoint in the booster system.
ID Object name
AO, 0 Set setpoint
AO, 1 Tank-filling start limit
AO, 2 Tank-filling stop limit
AO, 3 Tank-filling alarm high-limit
AO, 4 Tank-filling warning low-limit
AO, 5 Set max. flow limit
AO, 6 Set speed setpoint Pump1
AO, 7 Set speed setpoint Pump2
AO, 8 Set speed setpoint Pump3
AO, 9 Set speed setpoint Pump4
AO, 10 Set speed setpoint Pump5
AO, 11 Set speed setpoint Pump6
AO, 12 Set speed setpoint Pilot Pump
Set speed setpoint Backup
AO, 13
Pump
H: For MGE model H or newer
For Multi-E with CIM in each pump, always send all commands (writings) to all pumps.
A TPED model H is essentially a Multi-E model H with two pumps.
Related information
7.2 Setpoint
28
R/W Notes
Sets the booster system setpoint if bus control is
W enabled. A value of 0 does not imply a stop. See section
Setpoint.
W Sets the start limit in percentage of tank height.
W Sets the stop limit in percentage of tank height.
W Sets the alarm high-limit in percentage of tank height.
W Sets the warning low-limit in percentage of tank height.
W Sets the maximum flow limit value.
Sets the man speed setpoint pump1 if man start is
W
enabled.
Sets the man speed setpoint pump2 if man start is
W
enabled.
Sets the man speed setpoint pump3 if man start is
W
enabled.
Sets the man speed setpoint pump4 if man start is
W
enabled.
Sets the man speed setpoint pump5 if man start is
W
enabled.
Sets the man speed setpoint pump6 if man start is
W
enabled.
Sets the man speed setpoint pump1 if man start is
W
enabled.
Sets the man speed setpoint pump1 if man start is
W
enabled.
Unit
% ● ● ●
% - ● -
% - ● -
% - ● -
% - ● -
3
● - -
m /h
% - - ●
% - - ●
% - - ●
% - - ●
% - - ●
% - - ●
% - - ●
% - - ●
●
-
-
-
-
H
-
-
-
-
-
-
-
-