Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide
3.4.4 Connect Optical Fiber
1. Unscrew the three screws on the cover of the eNB wiring cavity using a Phillips-head screwdriver.
2. Open the wiring cavity.
3. Connect the optical fiber to the optical (OPT) interface in the wiring cavity.
4. Lay the cable along the wire groove, and stretch it out of the wiring cavity from the optical (OPT)
hole.
5. Redundant optical fiber cable should be neatly wound.
3.4.5 Connect Ethernet Cable
1. Connect the Ethernet cable to the Ethernet (ETH) interface in the wiring cavity.
2. Lay the Ethernet cable along the wire groove and stretch it out of the wiring cavity from the
Ethernet (ETH) hole.
3.4.6 Connect Power Connector
Since the length of cable needed for power varies from site to site, the two ends of the power adaptor are
bare terminal ends. You will need to make the length of the power cable according to the actual
measurements of the installation site, and assemble the power plug and power terminal on the two ends
of the power adaptor (Figure 3-13).
Figure 3-13: Power Supply Adaptor
•
AC Power
Baicells recommends installing an air switch in the distribution box to ensure lightning and
leakage protection. Optionally, you can use a socket or plug with a fuse (Figure 3-14).
The power cord should be wrapped in soft casing or wiring tube for protection.
Ground the distribution box and ensure the box is protected from leakage.
Figure 3-14: Distribution Box
23