Table of Contents
Advertisement
5. Using the two pins on the back of the unit bracket, attach the eNB to the bracket on the
wall. Push the eNB until the hook is firmly attached to the mounting bracket. Tighten the
bolt on the top of the bracket using a cross screwdriver to complete the installation
(Figure 3-10).
Figure 3-10: Attach eNB to Bracket
3.4 Connect Cables
3.4.1 Cable Laying Requirements
General requirements:
Bending radius of antenna feeder cable: 7/8 in > 9.84 in (250 mm),
4/5 in > 14.96 in (380 mm)
Bending radius of jumper cable: 1/4 in > 1.38 in (35 mm)，
1/2 in (super soft) > 1.97 in (50 mm), 1/2 in (ordinary) > 5 in (127 mm)
Bending radius of power cable and grounding cable: > triple the diameter of the cable
Bind the cables according to the type of cable; intertwining and crossing are forbidden.
An identification label should be attached after the cable is laid.
Grounding cable requirements:
The grounding cable must connect to the grounding point.
The grounding cable must be separated from the signal cables, of enough distance to avoid
signal interference.
20
Advertisement
Table of Contents
