Configure Basic Parameters; Launch The Enb Gui; Figure 3-23: Gui Login - Baicells Nova436Q Installation Manual

Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide

3.8 Configure Basic Parameters

Reference: 4G LTE eNodeB Configuration Guide – BaiBLQ
The Nova436Q eNB can be configured in SC, CA, or DC/split mode, depending on which licenses you have
purchased, and/or in HaloB mode, which is embedded in the base software. The Nova436Q also supports
CBRS SAS operation.
When first installing and testing the Nova436Q, Baicells recommends configuring the primary cell
(Pcell)/Cell 1 carrier settings (without enabling CA, DC, HaloB, or SAS) for simple verification that the new
eNB unit is operational. Once it is confirmed to be operational, you can then refer to the appropriate
configuration guide(s) for the operating mode you plan to use.
NOTE: For all GUI menus and fields, refer to the following documents on the Baicells website:
Baicells.com > Resources >
• CloudCore Configuration and Network Administration Guide
• Atom CAT4 CPE Configuration Guide
• Atom CAT6/CAT15 CPE Configuration Guide
• 4G LTE eNodeB Configuration Guide – BaiBLQ
• Carrier Aggregation and Dual Carrier/Split Mode Configuration Guide
• HaloB Solution User Guide
• SAS Deployment Guide

3.8.1 Launch the eNB GUI

Follow the steps below to connect to the Nova436Q GUI.
Step 1: Use an Ethernet cable to connect the eNB DATA port to the local network routed to the
Internet. The DATA interface is set to Dynamic Host Configuration Protocol (DHCP) client by
default.
Optionally, you can plug a Personal Computer (PC) directly into the eNB MGMT port. On
your PC you will need to assign a static IP address within the Management (MGMT)
subnet. The default IP address for the Management interface is http://192.168.150.1/24.
Step 2: Open a Web browser, and enter the following IP address: http://192.168.150.1.
Step 3: At the login screen (Figure 3-23) enter the default user name (admin) and password
(admin), and click on Login to open the home page.

Figure 3-23: GUI Login

Documents.
29