Table of Contents
Advertisement
6.
Proceed to "3.5 Connect Cable".
3.5
Connect Cable
3.5.1 Cable Laying Requirements
General requirements:
Bending radius of power cable and grounding cable: > tripled of the diameter of the
cable.
Bind the cables according the type of the cable, intertwining and crossing are
forbidden.
An identification label should be attached after the cable is laid.
Grounding laying requirements:
The grounding cable must connect to the grounding point.
The grounding cable must be separate with the signal cables, of enough distance to
avoid signal interference.
3.5.2 Connect Ethernet Cable
The diameter of the Ethernet cable must is not less than 7mm. Recommend to use
CAT6e shield Ethernet cable.
14
Advertisement
Table of Contents
