Install On Wall; Figure 3-9: Mark And Drill Holes; Figure 3-10: Attach With Expansion Screws - Baicells Nova436Q Installation Manual

Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide

3.3.2 Install on Wall

Ensure that the wall can bear at least four times the weight of the eNB. Follow the steps below to install
the Nova436Q eNB on the wall.
1. Take off the omega clamps of the pole/wall bracket so that only wall bracket remains.
2. Place the wall bracket on the wall with the arrow facing up, as shown in Figure 3-9. Mark the
drilling locations using a pencil or marker.
3. Drill two 0.4 in (10 mm) diameter, 2.8 in (70 mm) deep holes in the wall at the marked locations.

Figure 3-9: Mark and Drill Holes

4. Insert M8*80 expansion bolts and fasten. Check the up/down direction of the wall bracket, and
then attach to the wall using expansion bolts (Figure 3-10).

Figure 3-10: Attach With Expansion Screws

20