Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide
The home page is the Basic Setting > Basic Info menu, which reports the current eNB status (Figure 3-24).
In
section
3.8.9, use this page to confirm that the eNB is active.
Figure 3-24: Home Page
Optionally, you may want to:
1. Change the login password.
2. Confirm the firmware version is the latest available from Baicells website; upgrade if needed.
Firmware upgrades can be found at Baicells.com > Support > Firmware. See
detailed instructions regarding firmware upgrades.
3. Set the Network Timing Protocol (NTP).
For help, refer to the
CloudCore Configuration and Network Administration
3.8.2 Upgrade Firmware
Follow the steps below to ensure you are using the most recent software version before configuring the
eNB.
3.8.2.1 Upgrade Firmware from eNB GUI
1. Download the most recent firmware file from Baicells.com > Support > Firmware, and save on
local computer.
2. Go to the System > Upgrade sub-menu, and select the checkbox next to Preserve Settings if you
want to save the current configuration settings.
3. Choose Select File in the Upgrade Firmware pane, and navigate to the firmware file saved to the
local computer.
NOTE: The file type is *.IMG.
30
section 3.8.2
Guide.
for