Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide
Figure 3-27: LAN Config Tab
Table 3-1: WAN/LAN/VLAN
Field Name
WAN/LAN Config Tab
Connect Type Pane
Connect Type
WAN Config Pane
Index
WAN Name
IP Access Mode
Option60
Netmask
Gateway
Description
Used to select the type of connection for the eNB:
•
Copper: RJ-45 electrical interface
•
Fiber: optical fiber interface
The connection type is based on the eNB model. If the eNB doesn't support
optical ports, the value must be set to Copper.
The WAN index number, which is automatically generated. The eNB supports up
to four WAN interfaces.
The WAN Name is automatically generated.
Used to select the desired interface protocol to be used by the WAN interface:
•
DHCP: only the Option60 parameter needs to be configured if DHCP is the
interface protocol selected.
•
Static IP
•
IPv6 DHCP
•
IPv6 Static IP
Used to differentiate between different terminals when IP Access Mode is set to
DHCP. Range is 0–64 digits.
The IP address' subnet mask address. This parameter displays when IP Access
Mode is set to Static IP.
The default gateway's IP address. This parameter displays when IP Access Mode
is set to Static IP.
33