Table of Contents
Advertisement
19. Install all drives.
20. Connect all peripheral cables to the server.
21. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
22. If installed, close the cable management arm.
23. Power up the server.
The installation is complete.
Installing a stacking riser
About this task
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
Hardware options installation
159
Advertisement
Table of Contents
