Table of Contents
Advertisement
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Place the server on a flat, level work surface.
7.
Remove the access panel.
8.
Do one of the following:
Remove the air baffle.
•
Remove the midplane drive cage.
•
9.
Remove the fan cage.
10. Remove the midwall bracket.
11. (Optional) Install the front 2 SFF stacked drive cage.
12. Remove the drive box blank:
a. Remove the drive box blank screws (callout 1).
b. Remove the drive box blank (callout 2).
13. Install the universal media bay:
a. Install the universal media bay in the server (callout 1).
b. Install the universal media bay screws (callout 2).
Hardware options installation
92
Advertisement
Table of Contents
