Table of Contents
Advertisement
19. Install the access panel.
20. Connect all peripheral cables to the server.
21. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
22. If installed, close the cable management arm.
23. Power up the server.
The installation is complete.
Installing the front 8 SFF drive cage
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
T-10 Torx screwdriver
•
The components included with the hardware option kit
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the access panel.
Hardware options installation
140
Advertisement
Table of Contents
