Installing A Pcie Riser Assembly - Hitachi DS240 Service Manual

I H
NSTALLING THE ARDWARE

Installing a PCIe Riser Assembly

1. Remove the mainboard sled. See Removing a Mainboard Sled on page 2-11.
2. Align the guide pin on the riser assembly with the guide slot on the back chassis.
3. Align the guide hole on the base of riser assembly with the guide pin on the main-
board. Install the assembly on the chassis and press down firmly to connect it to the
mainboard.
4. Fasten the captive screw and press the latch plunger to the secured position to lock
the assembly.
Captive
Screw
Handle
5. Make sure the the assembly is secured in place.
Guide
Slot
Figure 2-22. Installing the Riser Assembly
I
NSTALLING A
Captive
Screw
Secured
PCI R A
E ISER SSEMBLY
Access
Opening
Guide
Slot
Latch Plunger
Latch Plunger
Open
2-17