Table of Contents
Advertisement
23. Power up the server.
24. If removed, install the front bezel.
The installation is complete.
Power supply options
Depending on the installed options and the regional location where the server was purchased, the server can be
configured with one of the supported Power supply specifications.
Power supply warnings and cautions
WARNING: To reduce the risk of electric shock or damage to the equipment:
•
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
•
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it. Pay particular
attention to the plug, electrical outlet, and the point where the cord extends from the server.
WARNING: To reduce the risk of injury from electric shock hazards, do not open power supplies. Refer all
maintenance, upgrades, and servicing to qualified personnel
CAUTION: Mixing different types of power supplies in the same server might:
•
Limit or disable some power supply features including support for power redundancy.
•
Cause the system to become unstable and might shut down.
To ensure access to all available features, all power supplies in the same server should have the same output and
efficiency ratings. Verify that all power supplies have the same part number and label color.
DC power supply warnings and cautions
WARNING: To reduce the risk of electric shock, be sure that the cable grounding kit is properly installed and
connected to a suitable protective earth terminal before connecting the power source to the rack.
CAUTION: This equipment is designed to permit the connection of the earthed conductor of the DC supply circuit to
the earthing conductor at the equipment. If this connection is made, all the following must be met:
•
This equipment must be connected directly to the DC supply system earthing electrode conductor or to a
bonding jumper from an earthing terminal bar or bus to which the DC supply system earthing electrode
conductor is connected.
•
This equipment must be located in the same immediate area (such as adjacent cabinets) as any other equipment
that has a connection between the earthed conductor of the same DC supply circuit and the earthing conductor,
and also the point of earthing of the DC system. The DC system must be earthed elsewhere.
•
The DC supply source is to be located within the same premises as the equipment.
•
Switching or disconnecting devices must not be in the earthed circuit conductor between the DC source and the
point of connection of the earthing electrode conductor.
Hardware options installation
100
Advertisement
Table of Contents
