Table of Contents
Advertisement
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Place the server on a flat, level work surface.
7.
Remove the access panel.
8.
Do one of the following:
Remove the air baffle.
•
Remove the midplane drive cage.
•
9.
Disconnect all power supply cables from the system board, drive cages, and devices.
10. Remove the riser blank.
11. Install the power supply cage.
a. Lower the power supply cage into the slot (callout 1).
b. Install the screws (callout 2).
Hardware options installation
110
Advertisement
Table of Contents
